Checking the oil level in the rear final drive
1. Place the vehicle on a level surface.
2. Remove filler plug with washer.
3. Make sure that the oil level reaches the edge of the filling hole.
4. If the oil level is insufficient, add oil to the rear final drive.
5. Install the filler plug with a new washer and tighten to 40-53 Nm.
Replacing the rear final drive oil
1. Place the vehicle on a level surface.
2. Remove filler plug.
3. Remove the drain plug and drain the oil into a suitable container.
4. Install the drain plug with a new washer and tighten to 40-53 Nm.
5. Fill with the correct grade of oil through the filling port until it starts to flow out.
Note:
Rear final drive oil:
- Oil grade: AP / GL-5
- Oil Viscosity: SAE BOW-90
- Filling capacity: 0.45 l
6. After filling the oil, install the filler plug with a new washer and tighten to 40-53 Nm.