Removing
Use a thin nylon cord to separate the adhesive joint between the mirror base and the black pad on the front glass.
Remove mirror.
Installation
Caution: Never touch or contaminate the black area (A) on glass (IN), adhesive mirror surface (WITH), because otherwise, sufficient strength of the connection will not be ensured.
Installing the old mirror
Clean the base of the mirror from adhesive residue with a rag and alcohol. Wait a few minutes until all the alcohol has evaporated.
The base of the mirror must be perfectly clean.
Remove the protective film from the new adhesive film and press the adhesive film firmly against the base of the mirror. О Clean the black area on the windshield.
Attention: For high-quality gluing, the glass must not be very cold, so the car must stand for at least one hour at a temperature of about 20°C.
Heat the base of the mirror and the adhesive film with a hair dryer for 30 seconds to a temperature of 50-70°C.
Peel off the protective film from the adhesive film on the mirror base.
Attention: If the mirror is installed on a new front glass, first remove the protective film from the black area on the glass.
Place the base of the mirror exactly on the black area on the glass and press it firmly for at least two minutes.
After 30 minutes of drying, adjust the position of the mirror.