1. Vacuum hose
2. Spring pin.
3. Connecting pin.
4. Fastening nut.
5. Vacuum brake booster.
6. Gasket.
Note:replace the part with a new one after each removal.
Caution: Since the brake switch gap is automatically adjusted, re-adjustment is not required. In addition, when replacing the brake booster or pedal, or after performing any procedure that changes the brake pedal travel, the brake switch must be replaced with a new one.
1. Remove the battery from the shelf.
2. Remove the windshield wipers.
3. Remove the upper hood grille.
4. Remove the drive with the windshield wiper rods.
5. Remove the hood panel.
6. Remove the master brake cylinder.
7. Remove the vacuum hose from the brake booster.
8. Remove the spring pin and take out the connecting pin.
9. Loosen the fastening nuts and remove the brake booster with the gasket.
10. Installation is carried out in the reverse order of removal.
11. After installation, add brake fluid to the reservoir, remove air from the brake system and check the brake fluid level in the reservoir again.
12. Remove the brake switch.
13. Check the brake pedal.
14. Install the new brake switch.