1. To turn the cleaner on and off, move the switch to one of the positions:
- position "OFF" - the cleaner is off;
- position "INT" - intermittent mode;
- position "1" - low speed operation;
- position "2" - work at high speed;
- position "
" - short-term windshield wiper activation mode.
2. To select the windshield wiper interval, move the switch to the "INT" position and rotate the knob as shown in the figure.
3. To turn on the windshield wiper briefly, move the switch to the "MIST" position.
The windshield wiper will operate for one cycle.
4. To turn on the windshield washer, pull the switch towards you and hold it until fluid sprays out.
If the switch is in the off position or in intermittent mode, the washer will operate as long as the switch is held.
Note: If the washer does not operate, do not try to turn it on again, but check the washer pump and the presence of fluid in the washer reservoir. The washer reservoir is located in the engine compartment. The location of the reservoir is indicated in the chapter "Maintenance and general inspection and adjustment procedures".