Contents: Removal ⇓ Installation ⇓
Removal
Disconnect the negative cable from the battery.
Note: This will erase the data from the electronic memory blocks, in particular the radio receiver security codes.
Pry up the watch with a small screwdriver, placing a piece of paper underneath it to avoid damaging the visor.
Caution: When disconnecting wires, be sure to pull only on the plug, not on the wires.
Pull the plug off the watch.
Using your finger, push the fog light switch out through the watch hole and hook it onto it.
Pull the plug off the switch.
Note: The switches for the rear fog lights, rear window heating and front window heating are removed in the same way.
Installation
Place the plug on the switch and insert the switch into the hole in the panel.
Place the plug on the watch and press the watch into the hole in the panel.
Connect the negative cable to the battery.
Set the clock readings and enter the radio receiver security codes if necessary.