Contents: Removal ⇓ Installation ⇓
Note: This only describes the differences that you need to pay attention to when removing the water pump. Since the right engine mount needs to be released, a lift or jack is required to raise the engine.
Removal
Loosen the four water pump pulley mounting bolts without removing them.
Remove the poly V-belt.
Loosen the bolts and remove the water pump pulley.
Unscrew the bolt and remove the tension roller.
Remove the timing belt completely.
Unscrew the six mounting bolts and remove the water pump together with the gasket.
Installation
Install the water pump with a new gasket and tighten the mounting bolts to 10 Nm.
Install the timing belt.
Install the tension roller and tighten its mounting bolt to a torque of 25 Nm.
Install the pulley onto the water pump and tighten the bolts by hand.
Install the poly V-belt.
Tighten the water pump pulley mounting bolts to 25 Nm.