Contents: Removal ⇓ Installation ⇓
Removal
Disconnect the negative cable from the battery with the ignition off.
Note: This will erase the data from the electronic memory units. See the instructions in the chapter "Electrical equipment".
Remove the door trim. Pull off the protective film in the door handle area, fold the film to the side and secure it with adhesive tape.
Loosen the screws and remove the rear glass guide (arrows).
Pull the glass guide out of the door.
Disconnect the door handle connecting rod from the door lock. To do this, press the tip of the plastic clip to the side and pull out the connecting rod.
Detach the connecting rod from the door handle.
Unscrew the two mounting screws and remove the door handle.
Installation
Install the door handle, align it and secure it with screws.
Attach the connecting rod to the door handle.
Attach the connecting rod to the lock, having first pressed the tip of the plastic clamp slightly to the side.
Insert the glass guide and secure it with bolts.
Stick the protective film.
Note: The film must be glued evenly, tightly and without folds, otherwise it will be pulled inside the door. Seal small cracks with adhesive tape. In case of major damage, replace the film.
Install door trim.
Connect the negative cable to the battery, set the clock and enter codes if necessary.