Contents: Removal ⇓ Installation ⇓
Removal
Disconnect the negative cable from the battery.
Note: This will erase the data from the electronic memory blocks. See the instructions in the chapter "Electrical equipment".
Remove the door trim. Pull off the protective film from the door frame.
(The primary source is the website: MazBook.ru)
Disconnect the inner door handle and the drive rod from the door frame.
Unhook the reinforcement pad, remove it from the side protective panel and take it out.
Remove the rear glass guide.
Unhook the door handle connecting rod from the lock. To do this, press the tip of the plastic clip to the side and pull out the connecting rod.
Unscrew the door lock screws.
If present, remove the plug from the alarm system switch. Unhook the switch and remove it.
Disconnect the door lock actuator wiring harness.
Remove the lock from the door and remove the drive motor plug.
Disconnect the wiring harness.
Remove the door opening switch by pressing it inward and fold it upward.
Remove the lock cover screws.
Pry up the through bushing for the inner door handle drive cable.
Unscrew the screws securing the drive motor from the door lock.
Disconnect the inner door handle cable bushing from the lock holder.
Align the cable (rod) of the inner door handle drive with the groove in the drive lever and unhook the cable.
Installation
Attach the inner door handle drive cable to the lock drive lever.
Attach the inner door handle drive cable bushing to the lock holder.
Install and secure the drive motor to the door lock with screws.
Insert the through bushing for the inner door handle drive cable into the lock.
Place the cover on the lock and secure it with screws.
Attach the door opening control switch to the lock.
Connect the wiring harness.
Insert the door lock into the door and put on the plug for the drive motor.
Attach the wiring harness to the door lock actuator.
If there is one, secure the alarm system switch and put the plug on it.
Tighten the lock mounting screws.
Attach the door handle connecting rod to the door lock.
Install the reinforcement plate into the door and secure it.
Secure the inner door handle drive and drive cable to the door frame.
Install door trim.
Connect the negative cable to the battery.
Restore the clock readings, enter codes if necessary.