Contents: Removal ⇓ Installation ⇓
Removal
Disconnect the negative cable from the battery with the ignition off. This will erase the data from the electronic memory units. See the instructions in Chapter "Electrical equipment".
Remove the door trim. Pull off the protective film in the area of the inner door handle, folding it down, and secure with adhesive tape.
Disconnect the inner door handle and the drive cable (rod) from the door frame.
Align the inner cable (rod) crank with the outer rod holder (mount). Press the lever up and unhook the inner and outer rods from the handle.
[The full text is on the website MazBook]
Installation
Attach the drive rod (cable) to the inside door handle.
Attach the inside door handle and the drive cable (rod) to the door frame.
Stick the protective film.
Note: The film must be glued tightly and without folds, otherwise it may be pulled into the door. Seal small cracks with adhesive tape. In case of major damage, replace the film.
Install door trim.
Connect the negative cable to the battery.
Set the clock readings and enter codes if necessary.