Contents: Removal ⇓ Installation ⇓
Removal
Disconnect the negative cable from the battery with the ignition off.
Note: This will erase the data from the electronic memory blocks. See instructions in Chapter. "Electrical equipment".
Remove the boot lid trim. To do this, open the boot lid, unscrew the plastic bolt above the lock drive and pry up the sliding clamp with a screwdriver. Use your fingers to pry the trim around the circumference from the nine clamps.
Disconnect the lock drive rod from the lock motor.
Loosen the lock mounting screws.
Carefully pull the lock out of the trunk lid and remove the trunk lid opening switch by pressing the switch inward and fold it up.
The original article is available on: www.MazBook.ru
Installation
Attach the trunk lid opening switch to the lock.
Carefully insert the lock into the trunk lid and secure it with bolts.
Attach the drive rod to the lock motor.
Install the trunk lid trim.
Connect the negative cable to the battery. Set the clock, enter codes if necessary.