2. Remove the license plate light bulb (see chapter "Body electrical equipment").
3. Loosen the mounting bolts and remove the rear bumper.
- Tightening torque - 79-116 Nm
1 - bolt,
2 - rear bumper.
4. If necessary, disassemble the rear bumper.
Disassemble in the sequence shown in the figure. Tightening torques for bolts and nuts securing parts are shown in the figure.
1 - rear bumper cover,
2 - bolt,
3 - piston,
4 - rear bumper,
5 - nut,
6 - rear bumper holder,
7 - rear bumper reinforcement.
5. Assembly is carried out in the reverse order of disassembly.
(The text of the article is taken from the website: «Mazbook»)
6. Installation is carried out in the reverse order of removal.
7. After installation, check and, if necessary, adjust the position of the rear bumper.