Removal and installation
1. Turn the ignition switch to the "LOCK".
2. Disconnect the cable from the negative battery terminal and wait at least 1 minute.
3. Remove the console (see chapter "Body").
4. Remove the passive safety system control unit in the sequence of numbers shown in the figure.
1 - connectors,
2 - bolts,
3 - control unit of the passive safety system.
5. Install in the reverse order of removal.
6. Turn the ignition switch to the "ON".
7. Verify that the SRS indicator lights up for approximately 6 seconds and then goes out. If the indicator does not light up, stays on or flashes, the system is malfunctioning. Run diagnostics.