Removal and installation the side impact sensor
1. Turn the ignition switch to the "LOCK" position.
2. Disconnect the cable from the negative battery terminal and wait at least 1 minute.
3. Remove the side impact sensor in the sequence of numbers shown in the figure.
1 - bolt "A",
2 - cover,
3 - connector,
4 - bolt "B",
5 - side impact sensor.
4. Install in the reverse order of removal.
(The article is copied from the resource MAZBOOK.ru)
5. Turn the ignition switch to the "ON" position.
6. Check that the SRS indicator comes on for about 6 seconds and then goes out. If the indicator does not come on, remains on, or flashes, the system is faulty. Perform diagnostics.