Checking the parking brake sensor (Mazda BT-50 (1))

1. Disconnect the parking brake switch connector.

2. Make sure there is continuity between terminal "A" of the sensor and ground when the parking brake is on and there is no continuity when the parking brake is off.

Replace the parking brake switch if necessary.

(The text of the article is taken from the website www.mazbook.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Vladimir Bazhenov

Share with friends on social networks:

Mazda BT-50 (1) » Brake system

Parking brake lever
Parking brake — device
Parking brake — checking and adjusting
Disassembly and assembly of the working brake cylinder
Rear brakes — removal and installation

Removal and installation parking brake cables
ABS System Diagnostics — System Description
Reading and erasing fault codes
Pressure modulator and ABS control unit
Front Wheel Speed Sensors — Checking

More articles on repairing other Mazda models
Checking the parking brake Mazda Familia 6 (1989-1994)
Parking brake — checking operation and adjustment Mazda Capella 3 (1982-1992, petrol)
Checking the operation of the parking brake Mazda3 BK (2003-2009)
Checking the operation of the parking brake Mazda6 GG (2002-2008)
Checking the Parking Brake Switch Mazda CX-5KE (2012-2017)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet