Attention:
- Before working on the air intake system, make sure the engine and intake system components are cool.
- Avoid contact of gasoline with rubber or leather items.
- After assembling the fuel system, check for fuel leaks and check the engine for leaks and fuel odor for a week.
- Before working on the fuel system, disconnect the negative battery cable.
- Do not smoke or use open flames when working on the fuel system.
1. Disconnect the cable from the negative terminal of the battery.
2. Remove the engine trim panel.
3. Remove the parts in the sequence shown in the figure "Removing and installing the air intake system".
Removal and installation the air intake system.
1 - mass air flow sensor / intake air temperature sensor #2 (seal P/N - WLS1-13-214),
2 - air duct,
3 - air filter housing cover,
4 - air filter (P/N - WE01-13-Z40),
5 - air filter housing,
6 - air intake,
7 - electromagnetic valve for regulating boost pressure,
8 - vacuum control valve,
9 - turbocharger outlet hose,
10 - turbocharger outlet pipe,
11 - charge air cooler inlet hose,
12, 15 - charge air cooler outlet hose,
13 - charge air cooler,
14 - charge air cooler outlet pipe,
16 - vacuum tube,
17 - throttle valve,
18 - bracket of electromagnetic valves of the exhaust gas recirculation system,
19 - boost pressure sensor/intake air temperature sensor No.2,
20 - intake manifold,
21 - throttle body gasket (P/N - WE01-13-234),
22 - intake manifold gasket (P/N - WE01-13-111).
4. Installation of parts during assembly is carried out in the reverse order of removal.
Note on removing the air intake
Before removing the air intake, it is necessary to remove the front wheel arch liner.
Note on removing the intake manifold
1. Move the fuel filter to the side without disconnecting the hoses.
2. Remove the EGR valve and EGR pipe (see chapter "Fuel injection system").
3. Remove the high-pressure fuel pipes (see chapter "Fuel injection system").
4. Remove the fuel accumulator (see chapter "Fuel injection system").