2. Remove the horn cover and trim, disconnect the horn wire (photo).
Remove the ornament to access the steering wheel cover screws
3. Make sure the steering wheel is disconnected, then remove the lock nut.
4. Mark the position of the steering wheel relative to the steering shaft.
5. Using a steering wheel extractor, remove the steering wheel (photo).
A steering wheel extractor can be used to remove the steering wheel
Warning: Under no circumstances should the end of the shaft be forged.
6. Assembly is carried out in reverse order with the following notes: before installation, lightly coat the contact surfaces of the horn with a small amount of grease on the steering wheel hub. When installing the steering wheel on the shaft, align the marks on the shaft and the steering wheel.