- 1. Pull the handle and lift the seat up and forward until it locks into place.
- 2 Pull the flyer and slide the seat cushion forward to install.
To dismantle the chair
- 1 Fold the seat cushion forward and downward.
- 2 Support the backrest from above with your left hand and pull the locking handle with your right hand. Lower the back down.
Caution! When you pull the locking handle, the backrest may tilt forward under its own weight. Therefore, to avoid injury, support the back from above as described above.
Carefully!
- Do not allow two people to sit on the third seat at the same time if their combined weight exceeds 80 kg.
- Do not install a child seat in place of a third seat. This seat is not designed for this type of use.
- Just like all other passengers, those occupying the third seat must wear seat belts.
- Make sure the rear seat is in an upright position when the third seat is used to prevent it from flipping forward into the vehicle in the event of a collision.
- Make sure the rear door is properly closed and locked when the third seat is in use.
- Ensure that passengers do not touch the rear lid lock button or handle while the vehicle is moving, as the rear lid may open and cause injury.
Attention!
- Before folding the third seat, fold the seat belt buckles using the rubber clip provided for this purpose. If this precaution is not taken, the seat and latches may be damaged.
- Be careful not to injure your fingers or hands when installing or removing the third seat.
Note: Follow the instructions when installing and removing the third seat. If you change the sequence or direction of the steps, you will not be able to install the seat correctly.
The original article is posted on [Mazbook]
 |
 |
 |
 |
 |
 |
