- 1 Grasp the seat belt tongue.
- 2 Slowly pull the belt out and place it across the middle of the shoulder and pelvic area.
- 3 Place the tongue into the slot of the lock. You will hear a click, indicating that the belt is locked.
Position the seat belt as low as possible across your pelvic area to prevent it from sliding down in the event of an accident. Adjust the belt to ensure it is positioned comfortably and correctly by pulling it slightly out of the retractor. The retractor is designed to remove excess belt parts and keep the belt taut.
Note: If the seat belt does not retract fully, try pulling it out and checking for knots or if it is reversed. Also check that the belt does not twist when retracted.
Caution! Seat belts should not catch on your hand. Never place the seat belt around your neck or on your inner shoulder. Make sure the smaller part of the belt is adjusted carefully in the pelvic area. The seat belt lap should be placed on the outer shoulder only. Failure to observe these precautions increases the risk of serious injury in the event of an accident.
[Content based on information from: mazbook]
To release the seat belts, press the release button located on the lock.
The seat belt adjuster allows four different adjustments to be made to suit the seat belt width depending on the passenger's size. To adjust the position, simply pull out the button, select a comfortable position, and then release the button.
 |
 |
 |
 |