In the event of an accident, air enters the fuel injection system. It is necessary to remove air from the system as follows:
1. Open the air filter cap.
2. Press the top of the filter in a downward motion.
3. Continue pumping until the fuel reaches the hole plug, and the fuel should not contain any bubbles.
4. Press down on the top of the filter and close the hole plug.
5. Repeat bleeding the fuel filter until bleeding becomes difficult (approximately 15 times).
Attention:
- It may take a while for the starter to start the diesel engine. However, do not hold the starter for more than 30 seconds when starting.
- If the engine does not start, wait 5-10 seconds before turning the starter again.
