2. Remove the refrigerant from the system.
Attention: to avoid contamination of the system, immediately install plugs on the open ends of the pipes.
3. Remove the grille.
4. Remove the cooling lines as shown in the figure "Cooling lines".
5. Install in the reverse order of removal.
Cooling lines.
6. Follow the steps described in subsection "Checking the efficiency of the refrigerant circulation system".
Note: when installing new hoses or pipes, add the required amount of compressor oil:
- Low pressure hose - 4 ml;
- High pressure hose - 5 ml;
- Refrigerant circulating tube - 4 ml.