Contents: Ford Ranger ⇓ Mazda BT-50 ⇓
Ford Ranger
Remove the parts in the order of their numbering in the assembly drawing " Removing and installing the master brake cylinder (Ford Ranger)".
Removal and installation the master brake cylinder (Ford Ranger).
1 - low brake fluid level sensor connector,
2 - brake pipe,
3 - bracket,
4 - master brake cylinder,
5 - O-ring seal.
Note: Installation is carried out in the reverse order of removal.
Mazda BT-50
1. Disconnect the connector from the low brake fluid level sensor.
2. Loosen the nuts and disconnect the brake pipes from the master cylinder.
- Tightening torque - 13 - 22 Nm
3. Remove the parts in the order of their numbering in the assembly drawing " Removing and installing the master cylinder and vacuum booster brakes (Magda VT-50)".
Removal and installation the brake master cylinder and brake booster (Mazda BT-50).
1 - nut,
2 - wiring bracket,
3 - master brake cylinder,
4 - clamp,
5 - vacuum hose,
6 - brake pedal fork lock nut,
7 - gasket,
8 - brake booster.
Note: Installation is carried out in the reverse order of removal.