- Standard set of tools
- Torque wrench
- Piston ring installation tool
- Piston ring puller
- Short pieces of rubber or plastic hose that fit tightly over the connecting rod bolts
- Plastigage
- Probes
- Fine file
- Fresh motor oil
- Engine assembly oil or molybdenum grease
- Sealant for RTV type gaskets
- Anaerobic type gasket sealant
2. To save time and avoid difficulties, assemble the engine in the following order:
- Crankshaft and main bearings
- Gearbox input shaft bearing on the crankshaft (models with manual transmission)
- Piston rings
- Piston/connecting rod assemblies
- Rear oil seal and cover
- Oil pump and oil strainer
- Pallet
- Flywheel, drive disk
- Front engine mount bracket
- Water pump
- Cylinder head, camshaft and rocker arm assembly
- Front oil seal and cover
- Sprockets and timing belt tensioning mechanism
- Toothed drive belt and its cover
- Fuel pump
- Rear casing
- Camshaft cover
- Oil pressure sensor
- Oil filter
- Thermostat and its housing cover
- Distributor, spark plug wires and spark plugs
- Assemblies of hoses and tubes of the cooling system
- Intake and exhaust manifolds
- Generator and brackets