Contents: Examination ⇓ Replacement ⇓
Examination
1. Raise and support the front of the vehicle.
2. Inspect the rubber shock absorbers on the mounts for wear and damage and replace them if necessary.
3. Check that the support bolts are tightly tightened.
4. Check that the bearings themselves are not worn out.
Replacement
Right support
1. Remove the through bolt of the support (A) and the upper bolts securing the support to the engine (B). Remove the support.
2. Installation is carried out in the reverse order of removal.
Front support
3. The front support is located between the engine and the radiator. Unscrew the through bolt of the front support (A) and nuts (B), remove the support.
4. Installation is carried out in the reverse order of removal.
Rear support
Caution! Access to this support is very difficult. To make access easier, you can remove the intake manifold.
6. Remove the through bolt, loosen the nuts and remove the support. Remove the support through bolt (A) and the transmission bracket bolts (B).
7. Installation is carried out in the reverse order of removal.
Left supports
Upper support
8. The support is attached to the body and the top of the gearbox. Remove the through bolt (A), bolt (B) and nut (C), disconnect the wires and unscrew the nut (D).
Lower support
9. The lower support connects the gearbox to the cross member located underneath it. Remove two nuts (A) and two bolts (B).