1. Turn on the lights
To light the fires, turn the button located on the end of the handle as follows:
First mark: Parking lights, license plate lights, taillights, and instrument panel lights.
Second mark: Headlights, parking lights, license plate lights, taillights, and instrument lighting.
Push the handle forward to turn on the high beam. Tilt the handle back to turn on the low beam.
Headlights on
To turn on the headlights, tilt the handle towards you as far as it will go, the handle will be released, it will be set automatically. This does not require the headlight switch to be in position "ON". high beam warning lamp (blue) lights up when the high beam switch is set to the position "ON".
Sound alarm
If you forget to turn off the lights after the engine has stopped, as soon as you open the door, a chime will sound.
2. Change of direction and lane change
Change of direction of movement.
Raise or lower the handle until it stops to turn on the alarm. After passing the turn, the signal will be automatically turned off.
Row change
Do not tilt the handle all the way down or up. Handle returns to position "arret" as soon as the rearrangement in the row is completed.
Sound signal
When the button is pressed, a signal sounds. Use the signal only when necessary.