Power steering pump installation details
2. Pulley nut; 3. Generator; 4. Drive belt; 5. Pulley; 6. Hose connector; 7. Return hose; 8. Pressure hose; 9. Suspension bolts; 10. Power steering pump
1. Disconnect the negative cable or battery.
2. Raise the front of the vehicle, support it securely on the jack stands, remove the right front wheel and mudguard.
3. Remove the power steering pump pulley nut.
4. Remove alternator and drive belt (Section 5). On air-conditioned models, also remove the compressor drive belt.
5. Remove the pulley from the pump.
6. Disconnect and close the power steering fluid ports.
7. Remove the four power steering pump mount mounting bolts and remove the power steering pump along with the mount assembly from the engine.
8. Assembly is carried out in the reverse order.
9. After installation, adjust the drive belt tension (Section 1), fill the pump reservoir with the specified fluid and bleed the system (Chapter 20).