Bleeding the power steering system (Mazda Capella GC)

1. After any operation where the power steering hoses were disconnected, the system must be bled to remove air from it and obtain proper steering performance.

2. Raise the front of the vehicle and support it on the jack stands.

3. Turn the front wheels completely left and right several times. Check the power steering fluid level and add fluid if necessary. Repeat this procedure until the fluid level on the dipstick stops dropping.

4. Start the engine and let it run at fast idle. Check the fluid level and add if necessary.

5. Bleed the system by turning the wheels from side to side without stopping. This will allow air to be expelled from the system. Be careful not to let the reservoir run out of liquid.

6. Once the air has been bled from the system, return the wheels to the straight-ahead position and leave the car open for a few more minutes before closing it.

7. Test drive the vehicle to ensure that the steering system functions as normal and is not noisy.

8. Recheck the fluid level to ensure it is up to the upper mark on the dipstick while the engine is at normal operating temperature and add fluid if necessary.