Starter and engine starting system (Mazda Capella GE)

The engine starting system consists of a battery, starter, solenoid relay and connecting wires. The solenoid relay is located on the starter.

When working on the engine starting system, observe the precautions provided for working on the engine electrical system.

Checking the operation of the starter and solenoid relay

Examination

1. First of all, check the connecting wires and the reliability of the connections. Check the battery charge. Check the reliability of the starter fastening. Check the fuses and the interlock switch on the transmission.

2. If the starter turns slowly, check the voltage supply to the starter. It should not drop below 8.0 volts.

3. If the starter supply voltage is OK, but the starter does not work, remove the starter and check the operation of the solenoid relay. Replace the starter or relay if necessary.

Removal and installation

1. Disconnect the negative battery cable.

2. Remove the air filter and air intake duct.

(Information copied from the portal: MazBook.ru)

Models with 4-cylinder engine

3. Remove the bracket located between the intake manifold and the starter.

Models with a 6-cylinder engine and automatic transmission

4. Disconnect the shift cable from the lever on the gearbox.

5. Disconnect the connectors of the wires that interfere with the removal of the starter and move the wires to the side.

6. Remove the gear shift cable mounting bracket.

All models

7. Mark and disconnect the wires from the terminals on the starter relay. Loosen the mounting bolts (indicated by arrows) and remove the starter (left - models with a 4-cylinder engine, right - models with a 6-cylinder engine).

8. Installation is carried out in the reverse order of removal.