Contents: Probe model ⇓ Mazda model ⇓
Warning. Halogen lamps are filled with pressurized gas and can break if their surface is scratched or dirty. Wear safety glasses and handle the lamp only by the base. Do not touch the glass of the lamp with your hand, as it is greasy. located on your fingers may cause the lamp to overheat and fail. If you touch the pampa with your hand, wipe it with a cloth soaked in alcohol.
1. Open the hood.
Probe model
2. Turn on the headlights and move the headlight housing to the upper position. Disconnect the cable from the negative battery terminal (see chapter 1).
Warning. If your car's radio has an anti-theft system, make sure you have the unlock code before disconnecting the battery,
3. Remove the screws securing the headlight trim panel (figure 14.3).
4. Loosen the mounting screws and remove the headlight mounting frame (figure 14.4).
5. Remove the headlight and disconnect the electrical connector from it (figure 14.5).
The original article is available on MAZBOOK.ru
6. Installation is carried out in the reverse order of removal.
Mazda model
7. From the back of the headlight assembly, disconnect the wiring connector, then remove the large rubber seal from the back of the headlight (figure 14.7).
8. Compress the spring clips and remove the lamp from the headlight housing.
9. Without touching the glass bulb with your hands, insert the new lamp into the socket, then insert the spring clip into place (see Figure 14.7).
10. Connect the wiring connector and make sure the headlight works.