2. Remove the air filter assembly.
3. Disconnect the choke cable from the carburetor by loosening the clamp screw, removing the cable housing from the clamp, and disconnecting the inner cable (photo).
Choke cable clamp screw (A) and inner cable tube (B)
4. Working inside the car, unscrew the round nut that secures the choke lever to the instrument panel (photo). Rotate the control knob 180° and remove the screw that secures the handle.
Air damper actuator lever, round nut shown and (marked with an arrow) countersunk screw of the handle
5. Remove the handle from the dashboard. Remove the screw that secures the switch indicator light and separate the switch (photo).
The full text is on the website www.MazBook.ru
Removing the throttle valve indicator light switch
6. Release the cable from the sealing ring of the heat-insulating shield and pull it into the vehicle.
7. Installation is carried out in reverse order. Adjust the position of the cable housing in the clamp to take up the slack in the inner cable.
8. Have an assistant pull the handle all the way out and make sure the choke plate opens and closes completely.
9. Install the air filter and reconnect the battery. Check that the throttle control lamp is working properly.