Contents: Trunk lid lock ⇓ Lock cylinder ⇓
Trunk lid lock
1. Open the trunk lid and mark the position of the lock relative to the lid (to facilitate subsequent installation).
2. Disconnect the actuator rod (if there is ohm) and the electrical wiring connector.
3. Unscrew the two mounting bolts and remove the lock.
4. Disconnect the lock opening cable from the lock.
5. The lock is installed in sequence. reverse of removal.
Lock cylinder
6. Remove the cylinder rod (if it exists), then remove the retainer (or unscrew the bolt) cylinder mounts. On models with an electric lock, disconnect the electrical connector from the cylinder.
7. Remove the trim panel and take the cylinder out of the cover.
8. The cylinder is installed in the reverse order of crushing.
The original article is available on www.MAZbook.ru